Hi Guys. I need a little help.
I have a couple of rapidex reels that I am working on. However I need some parts to finish the job. Does anyone know where I can find some parts for a rapidex? I need:
2 X Springs (the one that loads the leaver for taking the spool off)
1 X Leaver (that takes the spool off - pictured below)
1 X Spindle Cap with screws (pictured)
Any help in finding these parts to bring two reels back into use will be greatly appreciated.
Rapidex Spares
- MaggotDrowner
- Sea Trout
- Posts: 4022
- Joined: Sun Dec 16, 2012 11:32 pm
- 11
- Location: Nottinghamshire
Rapidex Spares
"I'd rather be fishing!"
MD
MD
- Harry H
- Rainbow Trout
- Posts: 3053
- Joined: Sat Sep 01, 2012 10:04 pm
- 11
- Location: Rayne, Essex
Re: Rapidex Spares
Gary Mills of Mill Tackle is your man
There are three things that improve with age: wine, friendship and water sense, and there's no short cut.
Anthony Shepherdson
Anthony Shepherdson
- MaggotDrowner
- Sea Trout
- Posts: 4022
- Joined: Sun Dec 16, 2012 11:32 pm
- 11
- Location: Nottinghamshire
Re: Rapidex Spares
Thanks, Harry.
I have purchased two of the release cap sets, so I should have a couple of spare bits too.
I'll put a link here to help anyone who may find this thread.
http://www.milltackle.com/store
I have purchased two of the release cap sets, so I should have a couple of spare bits too.
I'll put a link here to help anyone who may find this thread.
http://www.milltackle.com/store
"I'd rather be fishing!"
MD
MD