New model net making
Posted: Mon Jun 03, 2019 7:58 pm
Hi Gents
after making 15 nets model Gye from Farlows
it is time for a new model a Jack Hilton design net.
I ordered the T piece be course i can,t make the T piece my self at the moment but it will be possible in the future i hope, after all i have the sizes now to make a piece like that :-)
I started with the arms that i made from oak strips and made them 110cm long, to bent a brass strip from 2 mm tick was not easy but managed it the best way i could do and made two buses for the screws that will be soldered on the bent strip.
i have to taper the arms to finish and after that i start making the hard wood spreaderblock with ebonite or tufnol side plates and a pole lock screw 3/8 bsf on the lathe
I have this type net on my list to make for a long time and happy that i finally can make one.
will post updates when i did some more work on it
T piece
Laminated oak arms
Brass strips bent, Bushes made
Brass strips 2mm thick
after making 15 nets model Gye from Farlows
it is time for a new model a Jack Hilton design net.
I ordered the T piece be course i can,t make the T piece my self at the moment but it will be possible in the future i hope, after all i have the sizes now to make a piece like that :-)
I started with the arms that i made from oak strips and made them 110cm long, to bent a brass strip from 2 mm tick was not easy but managed it the best way i could do and made two buses for the screws that will be soldered on the bent strip.
i have to taper the arms to finish and after that i start making the hard wood spreaderblock with ebonite or tufnol side plates and a pole lock screw 3/8 bsf on the lathe
I have this type net on my list to make for a long time and happy that i finally can make one.
will post updates when i did some more work on it
T piece
Laminated oak arms
Brass strips bent, Bushes made
Brass strips 2mm thick