![Image](https://i.imgur.com/7cYixps.jpg)
![Image](https://i.imgur.com/3kW5WGn.jpg)
Laid the cork pages over the tape.
![Image](https://i.imgur.com/rQaPBl2.jpg)
![Image](https://i.imgur.com/TYnqx1e.jpg)
![Image](https://i.imgur.com/CueryHI.jpg)
and trimmed
![Image](https://i.imgur.com/E1c4585.jpg)
![Image](https://i.imgur.com/iLu8qaE.jpg)
the reel is 15/16ths of an inch or 2.4cm. The tape is 5cm width, so I cut it down the middle with a razor blade (watch your fingers!)
![Image](https://i.imgur.com/laZo2Ym.jpg)
![Image](https://i.imgur.com/X53ffv2.jpg)
wind on the reel
![Image](https://i.imgur.com/uvSksJo.jpg)
bingo!
![Image](https://i.imgur.com/pQvaMvX.jpg)
I did it in one long piece and there was no noticeable lump really and certainly not once the first couple of layers of line went on. Good luck!DWW wrote: ↑Sun Aug 02, 2020 4:48 pm Hi , I have just found this thread , and would like to do the same for my Seldex's. However , can you clarify if you wound the cork and tape onto the spool in one long piece please ? Or did you do it in stages ? If it was would on in its entire length did you get a "lump" where the first piece met the spool ?
Cheers
DWW