Tom Watsons of 5 Canal Street Nottingham

Do you know of a good traditional fishing tackle shop, past and present.
User avatar
Alchemist
Stickleback
Posts: 18
Joined: Thu Apr 28, 2016 4:57 pm
7
Location: Thatcham, Berkshire

Re: Tom Watsons of 5 Canal Street Nottingham

Post by Alchemist »

Here's my new "baby", a Tom Watson "Wasp"

Image

Image

No-one else made a bid on ebay!
Crisp, straight, good joints, a full-length tip, stoppers, plus bag. Underused, I'd say.
A couple of issues to put right. The rings are badly tarnished and need replacing, likewise the whippings are peeling, but not the rest of the rod or the intermediate tyings. The tip ring has been rewhipped and although it's agate, it has a screw fitting so is it standard or was it changed for swingtip use?
The butt is quite wide and as it's very light, it must be hollow-built. Middle section too?
It's more powerful than I expected, in the Avon-class and will make a good chub-tamer. Not sure about barbel though....
The rings are ridiculously small, but the blank is superb quality, so does anyone have any idea who the maker may be?
"Leave only footprints"

User avatar
Nobby
Wild Carp
Posts: 10975
Joined: Sun Oct 02, 2011 2:40 pm
12
Location: S.W.Surrey
Contact:

Re: Tom Watsons of 5 Canal Street Nottingham

Post by Nobby »

I have one of these too...it's an Aspindlae Aero 890 written up for Tom, I believe. This would date them to 1946to 1949 when the two brothers parted their ways, unless they were built to the same tapers by Peter Aspindale's father afterwards. And, yes the butt and middle are hollow built without dams...don't twist it!

User avatar
Alchemist
Stickleback
Posts: 18
Joined: Thu Apr 28, 2016 4:57 pm
7
Location: Thatcham, Berkshire

Re: Tom Watsons of 5 Canal Street Nottingham

Post by Alchemist »

Thank you for the advice and information Nobby, I feel like putting a "Do Not Twist!" label on it. I twist cane rods by holding the ferrules anyway.
I've found your other posts on this. (I've got to get used to a Forum, having never used one before and realise I should have done a wider search). I'll look up Aspindale Aero 890 next.
The only thing that is strange about the rod is the tiniest stand-off agate butt ring I've ever seen. It's ID is smaller than the first intermediate. Looking forward to working on it and getting the rings and whippings done.
Chris
"Leave only footprints"

User avatar
Nobby
Wild Carp
Posts: 10975
Joined: Sun Oct 02, 2011 2:40 pm
12
Location: S.W.Surrey
Contact:

Re: Tom Watsons of 5 Canal Street Nottingham

Post by Nobby »

It turned out we were all kidding ourselves that large butt rings enhanced casting. Even Richard walker may have fallen for this one. Aspindales may have known this all along as it is a trait of their rods to have small butt eyes. I must admit to see one smaller then the next eye does seem daft, but apparently it's best to get the line under control with a small butt eye first....though a trumpet shape, reversed is even better apparently.

User avatar
StefanDuma
Grayling
Posts: 503
Joined: Sun Jan 29, 2017 6:11 pm
7

Re: Tom Watsons of 5 Canal Street Nottingham

Post by StefanDuma »

I bought my first rod from Tom Watsons on Canal Street.

They did have a number of locations over the years and at the hight of their fame they even sold Hardy tackle.

My grandfather had two Hardy reels from them. I will post more I just need to dig out what I have.

Stef

User avatar
StefanDuma
Grayling
Posts: 503
Joined: Sun Jan 29, 2017 6:11 pm
7

Re: Tom Watsons of 5 Canal Street Nottingham

Post by StefanDuma »

I have found lots of items relating to Tom Watson his accounts from 1936 to 1940, fishing licenses from the 1920's 30,40 50 and 60's

letters regarding the gun trade rental agreements and his rent book from 1959 to 1966

Image

Hours of reading for me here.

Regards

Stef

User avatar
Olly
Wild Carp
Posts: 9086
Joined: Sat Dec 15, 2012 12:58 pm
11
Location: Hants/Surrey/Berks borders.

Re: Tom Watsons of 5 Canal Street Nottingham

Post by Olly »

Were most of his rods via Aspindales?

Off Topic - Re butt rings see the Fuji guide regarding sizes. That's why the inline rods were made!

User avatar
Nobby
Wild Carp
Posts: 10975
Joined: Sun Oct 02, 2011 2:40 pm
12
Location: S.W.Surrey
Contact:

Re: Tom Watsons of 5 Canal Street Nottingham

Post by Nobby »

Aspindale seems to have shut up shop when Tony Croft left in 1967 and then Peter Aspindale seems to have learned to make rods, having previously been in the office, giving the name yet another lease of life.
I do think 'someone else' was making rods, an ex-employee maybe......perhaps Ken Johnson working as Falcon Rods? I think he may have given his name to Taylor and Johnson who also made rods that look just like an Aspindale. That firm ended up briefly owning Hardy Brothers!

Certainly I have a Tom Watson 'Wasp' that is pure Aero 890 in both looks and feel...the weighted butt cap is my playing at trying to change the balance to lighten the tip:

Image

Image


And these come up from time to time: Taylor and Johnson Rapier

Image


Surely it's no accident that both rods are identical to Aspindale offerings, even down to the whipping and serial numbers?

User avatar
DickBrowne
Grayling
Posts: 607
Joined: Fri Apr 01, 2016 9:39 am
7
Location: North Bucks

Re: Tom Watsons of 5 Canal Street Nottingham

Post by DickBrowne »

Isis wrote: Mon Aug 27, 2012 2:55 pm Absolutely loved this tackle dealer. My local shops were Youngs of Harrow and Chubbs of Edgeware
Funnily enough, I fished this morning with my Tom Watson Rivercraft, which was restored by Clive Young, nicely tying together the ends of your opening :)
A well tended garden is a sign of an un-committed angler

The Gudgeon Curmudgeon - Small Fish Specialist - I’d rather bleak than blank!

User avatar
TraditionalAngling
Brown Trout
Posts: 1457
Joined: Sun Oct 16, 2011 2:55 pm
12
Location: Derby
Contact:

Re: Tom Watsons of 5 Canal Street Nottingham

Post by TraditionalAngling »

Being local to Nottingham I get a few Tom Watson rods.Have a Wasp and Hornet down to be restored.
Last edited by TraditionalAngling on Thu Dec 28, 2017 8:13 pm, edited 1 time in total.

Post Reply

Return to “Traditional Fishing Tackle Shops, Past and Present”